Angle Valve Tap

Product Information：

This Angle Valve Tap is an angle valve under the brass valve. The biggest feature of Angle Valve Tap is that it has three outlets, all of which can discharge water.

Product Size：

Are the triangle valves used in water heaters and faucets the same specifications?

The specifications of the triangle valve used in the water heater and the faucet are different, some are four-pointed, some are six-pointed, and their appearance is different;

According to the distinction of hot and cold triangle valves, there are two types: "cold" and "hot" (identified by blue and red signs). Most of the materials of the same model of the same manufacturer and the same model are the same, and there is no essential difference. The main difference between cold and warm The purpose is: cold and hot signs, mainly to distinguish which is hot water and which is cold water. Only some low-end slow-opening triangle valves are rubber ring spools. The rubber ring material cannot withstand 90 degree hot water and needs to be divided into hot and cold.

What should I do if the triangle valve in the kitchen is broken and half of it is inside the wall?

If it is made of zinc alloy, it can be knocked off with a sharp tool. If it is made of cast copper, use a small cone-shaped grinding wheel to install on a hand electric drill for grinding, so as not to damage the internal threads of the pipe fittings. The specific steps are: insert the broken wire extractor into the broken pipe on the wall; clamp the position of the tail of the extractor with a wrench; rotate it counterclockwise to take it out; rotate it slowly, and the triangle valve will be twisted out.

4 points whether the ceramic valve core triangle valve has a smaller water output than the spherical valve core？

The flow capacity of the valve is generally expressed by the flow coefficient, which refers to the flow through the valve when the front and rear pressure difference is one atmospheric pressure. The flow coefficient of the ball valve is generally greater than that of the angle valve, so the pressure difference between the front and rear of the angle valve is the same. , That is, when the water pressure is the same, the flow of the ball valve should be greater than that of the angle valve.

Is there a socket under the triangle valve?

It is not acceptable to have a socket under the triangle valve, otherwise it will easily bring safety hazards. Once the triangle valve and the water pipe behind it leak, it will leak into the socket, which is easy to cause a short circuit of the wire. If the decoration is not over, then it is recommended that you move the socket above the triangular valve; if the decoration is over, it is recommended to abandon the removal of this socket, wrap the inner thread with waterproof insulating tape, and cover it with a blank panel on the outside.

The correct solution of the triangular valve joint broken wall knocking out the wall:

First, you need to use a saw blade to saw the part of the angle valve broken in the wall into three or four grooves, and then use a screwdriver to knock out the angle valve. But in this process, we need to remind everyone: When using a saw to saw, be careful not to damage the thread in the water pipe. When sawing, saw a groove on the top, bottom, left, and right. It doesn't matter if you wrap the PTFE tape. . Buy a hacksaw blade for less than 1 yuan, an average of four, saw four lines, and then use a screwdriver and hammer to knock out the inside, it takes less than 20 minutes to complete. Or go to a hardware store to buy a tool called a "broken thread extractor", insert it into the broken part of the thread, turn it counterclockwise, and use even force to remove the broken screw.