Product Information：
This Mixing Valve Corner Fittings is a pipe fitting suitable for plumbing. It can also be called a 45°elbow, but its shape/appearance looks a little stranger than a regular elbow, but there is not much difference in essence.
Product Features:
When removing plumbing fittings, it is often encountered that the pipe fittings cannot be removed because they have been used for too long. It is recommended to try the following methods: First, heating method. If all water pipes are all iron fittings, you can try it if you are not afraid of heating. Second, use Loose King spray, spray it several times to see if it works. Third, destructive disassembly, use an angle grinder to cut, be careful when cutting, and be careful not to damage the thread of the pipe.
How to install the shower mixing valve and Mixing Valve Corner Fittings：
Install Mixing Valve Corner Fittings first, and then install the mixing valve: Wrap the raw material tape on the small diameter end (4 points) of Mixing Valve Corner Fittings, and connect it to the water outlet on the wall. Install both bent feet. Pay attention to the adjustment. The good center distance is 15CM, and the two ports should be on the same horizontal line. Take out the water mixing valve, install two rubber gaskets, align the two ports of the eccentric bent foot, and tighten the two nuts of the water mixing valve to complete the installation. Twist more raw material tape to tighten. Don't over-tighten it. Be careful to twist the pipe joints reserved in the wall.
Install the Mixing Valve Corner Fittings first, and then install the mixing valve: pay attention to adjust the distance to 15CM, and to be the same horizontal line, and then install the two rubber sealing hot quasi-bent feet of the mixing valve, tighten the two nuts of the mixing valve, and install it well. The reserved silk head of the flower wine faucet is just buried in the wall tiles, and it is best to cover it with a decorative cover.
