Brass Compression Valve

Product Information：

This Brass Compression Valve is a ferrule type copper ball valve under IFAN, which can be used in PEX piping system to connect with PEX pipe.

The Brass Compression Valve is a double ferrule ball valve, its handle is a red butterfly handle, the body is a two-color body, the ball core is an iron core, and the full port design can achieve maximum flow and minimum pressure drop; Made of brass, it is durable Durability and strength; Equipped with butterfly valve handle for easy grip to control flow; Designed and manufactured to high quality standards to ensure unparalleled functionality and durability after use.

Product Size：

Product Features:

The pipe joint in the form of a ferrule is suitable for use in places where the coal medium is oil, water, gas and other places without corrosion and corrosion characteristics. It is a kind of pipe joint with good airtight performance. After the road is connected, it is very flexible to use, and has the advantages of firm and reliable connection and excellent sealing characteristics.

Installation points of pipe joints in the form of ferrules: The pipes that need to be cleaned with an acid solution should be cleaned with an acid solution first; according to the length required in actual use, use professional tools to cut the pipe, and it is absolutely not allowed to use melting or The grinding wheel cuts off the burrs, metal chips and stains on the inner and outer circumferential cross-sections of the pipe ends; removes the anti-attraction additives and stains of the pipe joints in the form of ferrules; at the same time, it is also necessary to ensure the roundness of the pipes; put the nuts, Insert the ferrule into the pipe one by one, the cutting edge of the front end of the ferrule should be at least 3 mm away from the pipe mouth, and then insert the pipe into the tapered hole inside the joint until it cannot be inserted; slowly tighten it. Fix the ferrule nut, rotate the pipe until the pipe does not move, and then tighten the nut about 2/3 to 4/3 turns; disassemble and check whether the ferrule has been fixed into the pipe, whether the position is accurate, and the ferrule is not It is allowed to shift the direction of the axis, and it can be rotated a little; after checking that it meets the requirements, re-tighten the nut.

Points to note for the installation of high-pressure type ferrule joints: During the transfer or stationary process, the hose should not be bent excessively, nor should it be bent at the root, and should be bent at least at 1.5 times its diameter; hose transfer When it reaches the two ends, it should not be too tight, it should be relatively loose; try to prevent the twisting and turning of the hose as much as possible.

What needs to be vigilant is that when the ferrule joint is installed, it must be kept away from the parts that can generate heat radiation, and the heat shield should be installed when necessary.