Product Features:
Continuously monitor and adjust the indoor temperature for comfort and stability, relieve fatigue and pain;
The adjustable design ensures a tight shut-off of the steam and hot water system;
Brass casting body;
The control includes the ventilation of the steam of the valve body, which is in the normally open state, and the installation is simple and convenient;
No need to power on, saving power resources.
What are the installation requirements for the Temperature Control Radiator Valve?
The first requirement is to prevent clogging, the mesh filter must be installed in front of the automatic temperature control valve. And to install a bypass valve.
The second point is that the radius of curvature of the capillary tube should be greater than 50mm. Start to bend at a distance of 50mm from both ends. Do not bend the capillary arbitrarily to prevent breakage.
The third point is that when installing, you should pay attention to the medium flow direction to be consistent with the direction indicated by the arrow on the valve body, and do not install it backwards.
How is the Temperature Control Radiator Valve installed?
The first point is that when installing the automatic temperature control valve, we should first loosen the set screw of the temperature sensing part. In this way, the casing can be taken off and fixed on the device to be controlled, and then it can be sealed, the temperature sensing bulb can be inserted into the casing, and finally fixed with a fastening screw.
The second point is the specific installation of the automatic temperature control valve. The automatic temperature control valve should be installed on the heating pipe upside down vertically. That is, the actuator should be installed downward. In this way, the temperature sensing bulb can be arbitrarily installed on the controlled device, and the requirement is that the depth of the deep medium should be greater than 4/5 of the total, so as to ensure the accuracy of the measurement.
