Product Information：
This Coude Male Brass is a pipe fitting under IFAN. One end of it is a pipe fitting, which can be connected with PEX pipe; the other end is a female threaded fitting, which can be directly connected with a threaded fitting of the same size.
Coude Male Brass is a sturdy fitting, and when we were looking for a stable pipe fitting, the Coude Male Brass was an excellent choice: it has great strength, is strong and reliable enough to be well suited for PEX piping systems.
Coude Male Brass Installation Process: The easiest to install is the Brass PEX pipe fitting, you only need a small tool and you can easily complete it.
Product Size：
Size | PCS/Bag | Weight | CBM |
L16×1/2"F | 200 | 95 | 0.011 |
L18×1/2"F | 150 | 107 | 0.011 |
L20×1/2"F | 150 | 133 | 0.011 |
L20×3/4"F | 150 | 142 | 0.011 |
L26×3/4"F | 100 | 168 | 0.011 |
L32×3/4"F | 50 | 332 | 0.011 |
L32×1"F | 50 | 340 | 0.011 |
Product Features:
In the process of using the ferrule joint, its sealing is a very important performance. We need to do the sealing installation during installation. So how can the sealing installation of the ferrule joint be carried out? Let's take a look at the relevant instructions:
In order to ensure the installation and sealing of the ferrule joint, first cut off the seamless steel pipe of appropriate length with a saw blade, remove the port burr, and insert the nut and fastener on the seamless steel pipe; pay attention to the direction of the nut and bite, do not install it in reverse, Apply lubricating oil to the screws and ferrules of the pre-assembled joint body, insert the steel pipe into the joint body, and tighten the nut by hand; tighten the nut until the fermenter steel pipe is caught by the fermentor. This turning point can be felt by the increase in tightening torque. to; when the pressure point is reached, tighten the nut 1/2 turn, remove the pre-assembled fitting body, and check the insertion of the cutting edge of the ferrule, the visible protruding band must fill the space at the front of the ferrule, it can turn slightly, but Can not move axially; in the next installation, the thread of the joint body should be lubricated with lubricating oil, and the compression nut should be screwed together until you feel the tightening force increase, and then tighten the ferrule joint 1/2 turn, complete Install.
