Product Information：
How to open the Washroom Soap Dispenser: The cap of the Washroom Soap Dispenser is threaded and can be twisted from under the bottle, making it easy to unscrew. If the Washroom Soap Dispenser has been used for too long and is stuck by soap, detergent, and dirt, you can scald it with hot water to soften the stains, and it will be easy to unscrew it. After removing the soap pump, it is recommended to disassemble it. Lower the pump head and clean all components.
Product Size：
Size | PCS/CTN | Weight(g/pcs) | CTN SIZE |
6.6*8*22.7cm | 50 | 340 | 0.094 |
Product Features:
Sink Washroom Soap Dispenser—generally installed on the soap dispenser hole of the kitchen sink, if the sink does not have a soap dispenser hole, or the soap dispenser hole is occupied by the water purifier, you can install the soap dispenser by opening a new hole , Generally, electric hammer + stainless steel hole saw can be used to open the hole. If you can't operate it yourself, you can also ask someone to come to open the hole. The opening size of the Washroom Soap Dispenser is generally slightly smaller than that of the faucet, and about 25mm is more suitable. The specific size can be found in the specifications of the soap dispenser. Generally, a normal sink will have two holes, one large and one small, one for the faucet and one for the soap dispenser.
If there is a soap dispenser hole in the sink at home, but there is no Washroom Soap Dispenser installed, a water purifier can be installed in this position, but the faucet of the water purifier is different in style and size, and the hole size is also different. The hole diameter of the faucet of the water purifier is required It can only be installed when it is similar to the hole of the soap dispenser, otherwise it needs to be expanded or re-drilled. When the user uses the water purification faucet for the first time, the operating pressure must be adjusted to 0.2-0.4mpa when cleaning. Every time the pure water purification equipment is started, the reverse osmosis membrane function is automatically cleaned under low pressure. In daily use, care should be taken to ensure the internal and external sanitation of the pipeline. It is recommended to turn on the tap to rinse after using pure water, rinse off the residual pollutants in time, and maintain the high water flux of the pure water purification equipment to prolong the service life. The pure water faucet should always keep the ultrafiltration membrane filter element in a wet state when using it. If the water purification equipment is not used for more than three days, the water purification equipment should be rinsed repeatedly for 2-5 minutes when it is used again, until all the water stored in the water purification equipment is drained.
