Product Information：
The Brass anpression elbow is usually a 90 degree elbow, which is divided into equal diameter elbow, reducer elbow, male elbow,female elbow, etc. The usual size of the ferrule direct elbow is 16 mm to 32 mm. The usual abrasive tools are IFAN, IFANsupper, IFANplus, etc. The raw materials used are 58-3 copper, cw617 copper, and the main application is PEX-AL-PEX pipe, PE-AL-PE pipe connection, etc., usually the color is yellow-white, yellow , Three kinds of white.
Features of ferrule joints:
1. The ferrule joint is suitable for piping systems where oil, steam, and water are cut off.
2. It has advanced structure, good performance, easy to use, no welding, no need to expand the piping, etc.
3. Card sleeve type joints have been widely used in hydraulic and pneumatic systems of various machinery. Due to the high manufacturing precision of the ferrule and the complicated process, it is not suitable for sporadic or small batch manufacturing, and professional production is required.
4. The biggest feature of the card sleeve type is that it is very convenient to install, as long as it can be installed with a wrench. The ferrule type joint is tightened by tightening the nut to tighten the ferrule in the 24" cone of the connector, forming an effective hard contact seal while the ferrule bites the steel pipe. The elastic ferrule sealing ring technology can further improve the ferrule type The ability of the joint to resist leakage.
5. Compared with the welded joint, it will not pollute the cleanliness of the pipeline due to the production of oxide skin during the installation process. The bite type joint is widely used in high and low pressure common piping systems, but the bite type joint requires the use of precision seamless steel pipes.
Description of the role of pipe fittings:
1. During the process of tightening the nut, the single ferrule will be squeezed into the cone.
2. Under the action of the nut, the cone guides the inner blade of the single ferrule to cut into the surface of the steel pipe.
3. A ring-shaped protrusion is formed on the end face of the inner blade.
4. The steel pipe is squeezed in the body of the pipe joint, and is sealed by a suitable and clean pre-installation. On the other side, the single ferrule bites the steel pipe through the squeeze of the nut. In the case of a dynamic load, there is an additional bite force at this squeezed position. If the steel pipe is sawed vertically and cleanly deburred, the three important parts of the installed joint can be sealed.
