If the floor heating pipe is broken, first find the broken position, and then use a special pipe cutter to cut the broken place. Then smooth the interface, remove the burrs, and then perform thermal fusion. When hot-melting, use a dry cloth to wipe the inside and outside of the floor heating pipe clean, and then use a pipe of the same size and brand as the pipe for hot-melting. Prepare the fuser first, and then turn it on to heat it up. Then use a pen to draw the required length at the position where the pipe is hot-melted, wait until the heating reaches a certain level, then quickly remove the pipe from the heating jacket, and then insert it into the pipe fitting. Then treat their joints evenly and correct the joints. However, it cannot be rotated, and the angle between the pipe and the pipe must be maintained at 180 degrees. Then wait until the specified time and then perform the pressure test. If there is no pressure relief, it can be used normally.
