Installation of the vegetable basin faucet: First, put the O-ring into the base groove, then insert the faucet as a whole into the sink hole, then insert the rubber gasket and stainless steel gasket into the threaded pipe in turn, and cover the water inlet hose separately. Put it into the lower connection sleeve, then press the water inlet hose to connect the hot and cold water inlet pipes respectively, screw the lower connection sleeve into the threaded pipe, adjust the faucet in the sink position, and lock it firmly. Installation steps of the vegetable basin faucet: close the water valve under the vegetable basin, and use pliers to unscrew the interface between the faucet and the hot and cold water pipes; separate the vegetable basin from the sealant on the marble surface, and slowly use props along the edge. Cut open, take out the vegetable bowl, unscrew the old faucet, install the new faucet on the vegetable bowl according to the instructions; put the vegetable bowl back on the marble surface, then connect the hose under the sink and the hot and cold water Tighten the water pipe interface, and then open the water valve to see if there is water leakage. Leakage requires interface processing.
