Frequently asked questions about showers：
Question: When using a rain shower, I found that the water is not a jet-like fine water stream, and some places have a thick water column. What should I do?
Answer: There are two reasons why the fine water of the shower sprinkler becomes a mixed thick and fine water. The first is that the spraying method of your shower is adjustable. You can adjust the sprinkler head by rotating it. If it is not adjusted, the reason is that the sprinkler is too dirty Use a small flat-blade screwdriver to open the small round cap in the middle of the nozzle, unscrew the screw with a Torx screwdriver, turn on the shower, rinse with clean water, brush the shower hole with a toothbrush, and then install and restore.
Supplement: Showers with adjustment functions generally have several water outlet methods. Adjusting the adjustment dial will perform function conversions based on internal results, such as showers, large and small pulses, and mixing functions.
Question: The shower will often get blocked if it is used for a long time, and some holes will leak out, but some will not. What should I do?
Answer: There are two types of sprinkler spouts on the market, one of which is made of hard material. You can only use the cleaning needle to remove the dirt when cleaning. There is also a soft material, usually silica gel, which can be used to remove dirt by hand. The latter is recommended. However, due to the different quality and grade of silica gel, you must ask carefully when purchasing.
Supplement: The face mask on the shower head generally contains a self-cleaning sheet. The function of the self-cleaning sheet is to adjust the amount of water and to clean it. The self-cleaning sheet is generally made of rubber or silicone.
Shower repair method：
1. The basin faucet and kitchen faucet have a small water output and no foaming
Possible cause: The water pressure is too low and the bubbler cannot produce bubbles.
Solution: Remove the faucet and replace it with a new aerator.
2. Water leaks at the connection between the hose and the faucet
Possible reasons: improper installation, deformation of the rubber ring, uneven or thin outlet pipe joints, or mismatch between the hose and the faucet.
Solution: Select the appropriate hose and faucet according to the specifications, replace the rubber ring, and reinstall.
3. The water temperature is low
Possible cause: The power of the water heater is insufficient and the temperature is not properly adjusted.
Solution: Adjust the temperature control button or buy a larger water heater.
Shower maintenance tips：
Invite experienced professionals to carry out construction and installation. When installing, the shower should try not to hit hard objects, and do not leave cement, glue, etc. on the surface, so as not to damage the gloss of the surface coating. Pay special attention to the installation after removing the debris in the pipeline, otherwise it will cause the shower to be blocked by the pipeline debris, which will affect the use.
When the water pressure is not less than 0.02mPa (ie 0.2kgf/cubic centimeter), after a period of use, if the water output is found to decrease or even the water heater is turned off, it can be placed at the water outlet of the shower. Gently unscrew the screen cover to remove impurities, and it will generally recover. But remember not to forcibly disassemble the shower head. Due to the complicated internal structure of the shower head, unprofessional forcible disassembly will cause the shower head to be unable to restore the original.
Don't use excessive force when turning on or off the shower faucet and adjusting the spraying mode of the shower, just turn it gently. Even the traditional faucet does not require much effort. Pay special attention not to use the faucet handle and shower bracket as a handrail to support or use.
The metal hose of the shower head of the bathtub should be kept in a natural stretched state, and do not coil it on the faucet when not in use. At the same time, be careful not to form a dead angle at the joint between the hose and the faucet, so as not to break or damage the hose.
