Shower Hose installation and use steps: design water supply pipeline → install water supply pipeline → set power supply circuit → pipeline flushing → fix the bottom plate → connect power supply line → water test, adjustment → use. The power supply of Shower Hose must be dry, and pay attention to safety. Note that the distance between the power supply should be <50M, and each power supply must be independent and cannot be connected in parallel. When the main power line passes through the three-way junction box, a U-shaped bend with a length of 4cm should be left. After peeling off, connect the random power line according to the red positive and black negative polarity. The joint is tightly wrapped with waterproof tape, and the power line has a waterproof plug. Throw one end out and keep it. When installing the Shower Hose, be sure to fix the bottom plate first. It is best to mark the outer edge of the bottom plate on the fixing hole, then drill 4-6 holes with a depth of >29MM, and then fix the bottom plate. Pass the upper decorative plate through the water outlet and the water inlet at the same time, and press it into the top of the shell; then smooth the water inlet management, put a 4-point rubber pad on it and connect it to the water inlet; then slide the outlet pipe lock nut from the upper end of the water outlet pipe to On the clasp, put a "tapered rubber ring" on the lower end of the outlet pipe, insert it into the outlet, and lock the lock nut; put the upper end of the outlet pipe on the fixing seat, press it with a fixing cap, and use 2 M4 ×15 stainless steel self-tapping screws to fix it; then assemble the shower head, place a 4-point rubber pad on it and screw it to the water outlet. Check the pipeline again, and then pass the water first, observe whether there is any water leakage, and deal with it properly; then turn on the power, and test whether the nozzles are normal and whether the water is flowing or not.
